RAMBo (RepRap Arduino-compatible Mother Board) 1.1B
by MFG41BB77BD last updated Sep 28 2017
Rambo1-1-schematic.png

Rambo1-1-schematic.png

Additional File

Description

RAMBo (RepRap Arduino-compatible Mother Board) is an all in one RAMPS class motherboard targeting convenience, reliability, and performance.

Logic

Arduino MEGA compatible Atmega2560 and Atmega32u2 processors are compatible with all RAMPS class firmware

Crystals for both usb and mcu (timing accurate to 10ppm)

4 Thermistor jacks

All extra pins broken out on both processors (allows using the 32u2 for LUFA AVR programmer, etc.)

2 channel SDRAMPS compatible SPI breakout

Motor Drivers

5 A4982 1/16th microstep motor drivers (A4984 1/8th prior to v1.1) (2 connectors on Z for Prusa Mendel and other dual Z printer designs)

Digital Trimpot for stepper current control

Current limit on driver IC VCC to prevent permanent latchup

Microstep mode configured by MCU through firmware (no jumpers needed)

Test points for driver control signals

Step and Direction pins are on their own ports for synchronous movement capability

Extra driver ports broke out for up to 3 additional drivers (some of the motor extension pins are shared with max endstop and a pin allocated for SPI-SS extensions)

PWM DC outputs (Extruders, Fans, Etc.)

6 outputs

Low resistance mosfets for cool running

Indicator led for each channel

Power

Three independent power rails for flexible input power configurations

Heated Bed, 15A 12-24V (version earlier than 1.1 limted to 14A 16V due to fuse rating, see rambo_development for hacks)

Extruders and fans, 5A 12-24V (fuse can be exchanged for up to 10A capacity) 10V-26V input voltage

Motors and logic, 5A 12-24V (fuse can be exchanged for up to 10A capacity) 10V-26V input voltage

Built in SMPS for 5V generation from Motor Power Input2

PCB

4 layer

2oz copper on all layers

High quality, High temperature FR4-TG130 PCB

Gold ENIG finishing

RAMBo v1.1 has 3 replaceable fuses. The small white fuse holders are Little Fuse OMNI-BLOCK fuse holders. They are compatible with NANO2 Fuses. Fast or very fast acting are recommended. An example part number for replacement fuses is 0448005.MR

F2 supplies the motors and on-board power supply.

F3 supplies the extruder heater and fan outputs.

F4 is a 15A ATO (the type found in many automotives). F4 supplies the heated bed output. (Version 1.0 has 11A PTC self resetting fuse)

Name File Type File Size (kb)
Icon Rambo1-1-schematic.png Image File (.PNG) 264
Icon Rambo-conn-all.jpg Image File (.JPG) 330
This project has not yet received a manufacturer's response. Start a new request.
You need to log in to post a comment.
Manufacturer since Sep 2017
3D Print Only

License Info

Public Domain Mark

RAMBo (RepRap Arduino-compatible Mother Board) 1.1B uploaded by unknown is free of known copyright restrictions.

Statistics
  • Views 517
  • Likes 0
  • Downloads 1
  • Quotes 0
  • Comments 0